Insertion of Lens

Insertion of Lens Step-by-step

To avoid mix-ups, develop the habit of always inserting the first lens in your right eye. Before inserting the lens, check to see it is free of any nicks or tears. If it appears damaged, throw it away. Check the lens has not turned inside out. Place the lens on the tip of your forefinger and hold above eye level; you are looking at the bowl of the lens from the outside.

  1. Remember to start with your right eye. Once the lens has been examined and you are sure it is not inside out, place it on the tip of your forefinger.
  2. Place the middle finger of the same hand close to your lower eyelashes and pull down the lower lid.
  3. Use the forefinger or middle finger of the other hand to lift the upper lid and place the lens on the eye.
  4. Gently release both lids and blink.
  5. Repeat these steps for the left lens.  *There are other methods of lens placement. If the above method is difficult for you, your Eye Care Practitioner can provide an alternative. Usually, the lens centers itself automatically on the middle of your eye when insert it and will very rarely be displaced on to the white of your eye during wear. However, this can occur if insertion and removal are not performed properly. To center a lens, follow either of these methods.
  6. Close your eyelids and gently massage the lens into place through the closed lid.
  7. Or, Gently manipulate the off-centered lens onto the middle of your eye while the eye is opened, using finger pressure on the edge of the upper or lower lid. If your vision is blurred after inserting the lens, check for the following;
  8. The lens may not be centered on the eye. Check the instructions above.
  9. If the lens is in the correct position, remove it and look for the following;

         a. Cosmetics or oils on the lens. Remove it and wear again.

         b. The lens may be on the wrong eye.

         c. The lens may be inside out, which would also make it less comfortable than normal.


Removal of Lens Step-by-step

  1. Always remove the right lens first.
  2. Wash, rinse and dry your hands thoroughly.
  3. Always ensure that the lens is on the middle of your eye before attempting to remove it.
  4. To locate the lens, inspect the upper area of the eye by looking down into a mirror while pulling the upper lid up. Then inspect the lover area by pulling the lower lid down.
  5. Once you have found the lens, you can remove it by using the pinch method introduced below or any other method recommended by your Eye Care Practitioner.
  6. Look left, slide the lens down to the white of your eye using your forefinger.
  7. Gently pinch the lens between your thumb and forefinger and remove the lens.


Caring for Lens and Lens Case

For the continued safe and comfortable use of your contact lenses, it is important to follow the instructions given to you by your Eye Care Practitioner. failure to follow the correct lens care regime may result in the development of serious eye problems. Cleaning and rinsing are essential to remove mucus, secretions, and deposits which may have accumulated during use. Do this immediately after removing your lenses and prior to disinfection. Harmful germs can only be removed by cleaning, rinsing and disinfecting. 


Using Eye Drops

  1. Tilt your head back.
  2. Pull your lower lid away from your eye to form a "pocket" by either (1) pulling your lower lid down with your index finger or (2) pinching the lower lid with your thumb and index finger and pulling out.
  3. Hold the bottle upside-down with the other hand, and let a drop fall into the "pocket." Don't let the tip of the bottle touch your eye or eyelid.
  4. Close your eyes (don't blink) and apply light pressure to the point where your lids meet your nose. Hold for two to three minutes.
  5. Before you open your eyes, wipe the unabsorbed drops and tears from the closed lids with a tissue.
  6. If you are taking more than one type of eye medication at the same time, wait three to five minutes before using the second drops.


Safety Tips